User's Manual

93
Figure D.10 – Supervisor Connection and Driver Selection
Figure D.11 illustrates the settings that are configurable using the Expert driver. As
explained earlier, some settings are only software configurable if the hardware
switches are set appropriately. For example, the baud rates for bus 1 and bus 2 are
software configurable based upon the configuration of the baud rate switches on
the side of the board (S5). If the hardware switches prevent software configuration
for a specific setting, the user control will display the current setting, but will be
disabled and read-only.
Figure D.11 – Software Configuration
To setup or view the individual address of a rack card click on the Device ID control
(see Figure D.11).
The pin out of the Click! 112/114 backplane contacts is shown in Figure D.13.