User's Guide

Chapter 2: Installing the XP20
•
15
12 Snap the connector insert on top of the pin housing. Again,
you'll have to align it properly.
13 Slide the rubber seal inside the clamping ring.
Figure 14. Completed connector
14 Insert the whole assembly into the backshell, twisting the back-
shell until it slips over the alignment marks in the connector
insert; slide the backshell nut forward over the cable and screw
the two together using two 18 mm wrenches.
Applying silicon dielectric compound
Figure 15. Applying the compound
1 Tear the tab o the tube of silicon dielectric compound that
came with the sensor.
2 Squeeze about a quarter of the compound onto the connector
at the base of the sensor.