User's Manual

22 Wavion Networks
Figure 4.10 Connecting antenna
W ARNING : Only connect the unit to the power supply once all the antennas
are connected.
W ARNING : Use caution when connecting the antennas. Undue haste can
damage the unit.
W ARNING : Do not screw in the antenna when holding the top section of the
antenna. You will most likely damage the antenna.
The successful insertion of six antennas should look as follows.
Connecting Power and DATA
The following describes how to apply power and data to the WBS-2400/5800X
Caution : You must always install an external grounding wire. Perform a
simple continuity check between the WBS-2400/5800and the ground
termination point to confirm. You must also ground the outdoor data
protection device to a ground rod or a bonded pipe. Make sure you have
completed grounding before you connect power to the WBS-2400/5800X.