User's Manual

26 Wavion Networks
Connecting Power and DATA
The following describes how to apply power and data to the WBS-700
Caution: You must always install an external grounding wire. Perform a
simple continuity check between the WBS-700and the ground termination
point to confirm. You must also ground the outdoor data protection device
to a ground rod or a bonded pipe. Make sure you have completed
grounding before you connect power to the WBS-700.
The Wavion WBS-700 is equipped with two RJ45 connectors. The right hand port named
"TEST" is for engineering use. Use the ETH port to connect data and power cable.
Figure 4.15 Connecting PoE cable
WARNING: The port named "TEST" is for engineering use only. In any
case do not connect PoE source to "TEST" port (!)