User's Manual

Table Of Contents

WBSn-2400 Quick Start Guide Page 3

Introduction

This document is intended to help you set up and configure your WBSn-2400-O or WBSn-2400-S base

station, using the online Setup wizard.

Note: Throughout this document, unless specified otherwise, the use of the product name WBSn-2400

refers to both the WBSn-2400-O and WBSn-2400-S base stations.

WBSn-2400 Pre-Installation Checklist

The following checklist covers all the procedures and equipment that you need to acquire and assemble,

prior to beginning the installation and configuration procedures. Ensure that you check this list carefully,

before beginning any of the procedures described later in this Guide.

Warning

Only experienced installation professionals who are familiar with local building and safety codes

and, wherever applicable, are licensed by the appropriate government regulatory authorities

should install outdoor units and antennas.

Failure to comply with this may void the WBSn-2400 product warranty and may consequently

expose the end user or Service Provider to legal and financial liabilities.

Wavion and its resellers or distributors are not liable for injury, damage or regulation violations

associated with the installation of Outdoor Units or antennas

Check contents of package

WBSn-2400-O

• WBSn-2400-O base station unit (Omni)

• PoE injector unit

• 3 antennas

• Post-clamp

• Two steel bands

• 4 screws, each with attached spring and flat washers

• Iron security cable

• Waterproof sealing tape for IP67 (band to sealing rubber)

• Plastic cap and cap cover

WBSn-2400-S

• WBSn-2400-S unit (Sector)