User's Manual

WBSn-2400 Quick Start Guide Page 7
Safety instructions and information
Please ensure that you read and understand the following safety information. Ensure that you
carefully read and follow all instructions in this manual, and heed all warnings.
Warnings
It is illegal to modify the construction of this product. Modifying the
operating frequency or enhancing the transmit output power through the
use of external amplifiers or other equipment is specifically disallowed by the
"Telecommunications Act.
There is a risk of personal injury or death if the WBSn-2400 antennas are
close to electric power lines.
By nature of the outdoor installation, you may be exposed to hazardous
environments and high voltage. Use extreme caution when installing the
system.
All servicing should be referred to qualified service personnel only. There are
no user-serviceable parts inside. Servicing is required when the apparatus
has been damaged in any way.
This apparatus must be properly grounded.
Do not open the unit – risk of electric shock.
Any change or modification not expressly described in this manual or
approved by the manufacturer could void your authority to operate this
equipment.
The WBSn-2400 should only be installed using the antennas that were
provided as part of the original package.
A minimum distance of 40cm should be kept from the WBSn-2400 antenna
when the system is in operation.
Only UL-listed parts and components should be used for installation.
To maintain Overvoltage (Installation) Category II, install a suitable surge
suppressor device in the branch circuit to limit expected transients to
Overvoltage Category II values. The limits are based on IEC60664 and are
also located in Table 2H of UL60950 (for mains 110V, the transient rating is
1500V).