User Manual
Table Of Contents
- 1. Introduction
- 2. Installation
- 3. Defining and Managing WBSn
- 5. Appendix a: Troubleshooting
- 6. Appendix B: Frequently Asked Questions
- 7. Appendix C: Hardware Specification
- 8. Glossary
WBSn-2450 User Guide Page - 17 -
3.1.1 Checking System Setup
Navigate to Status => System for an overall view of the system settings.
Parameter Description and values
Time Indicates the unified time of the unit, according to the NTP server, and your
specific time zone.
Software Versions Displays the current (and previous or alternative, where applicable) software
(firmware) version. For more information, see the Firmware
section.
Resource Utilization Indicates the resources utilized by the system
Country Code Displays the available country codes for your location, according to the
regulations of which your base station is set to operate. Note: Changing of
regulatory domains (country codes) is not permitted for any product sold in
North America.
Hardware Information Indicates description, part names and serial numbers of the existing
hardware, plus the temperature of the unit. For further information about the
hardware configuration, see Appendix C
.
3.1.2 VAPs
Navigate to Status => Wireless => VAP => VAP Table for an overall view of the all current VAPs.
Navigate to Status => Wireless => VAP => Associations => Association Table for an overall
view of all current connections.
For more information, see To Define a VAP
.
3.1.3 Wireless Associations
The Wireless associations list is a list of clients that are connected to the base station. You can access
this list by navigating to Status => Wireless => Associations, where the following list parameters
are displayed.
Parameter Description
IP Address IP address of the associated station
MAC MAC (Media Access Control) address of the associated station
SSID SSID to which the station is associated
RSSI dBm The RSSI (Received Signal Strength Indicator) power received by the WBSn
base station from the associated station.
TX Rate The average PHY Rate (modulation) at which the base station transmits to the
associated station
RX Rate The average PHY Rate (modulation) at which the associated station transmits
to the base station
State Indicates the status of the station’s connection:
• Disconnected
• Association_Processing
• Associated
• Disconnecting
Est. Range Estimated range of client from WBSn