User Manual

WBSn-2450 User Guide Page - 18 -
Parameter Description
WMM A value of Yes in this field indicates that the associated station supports the
WMM protocol
Auth. Status Radius authentication state
Radio 2.4 GHz, or 5.0 GHz, or 2.4 GHz + 5.0 GHz
PS Power Save status
11N Indicates whether the associated station supports 802.11n protocol
TX [Bytes] Amount of bytes transmitted towards the associated client
RX [Bytes] Amount of bytes received from the associated client
Time since
assoc.
Time since association
Time since last
activity
Time since last reception of data from the client
TX Packets Amount of packets transmitted to the associated client
RX Packets Amount of packets received from the associated client
TX PER [%] Packet Error rate on the Tx transmission path
# of streams
support
Number of streams supported by the client
TX BF support
indication
Indicates whether the clients supports Beamforming from the WBSn-2450-X.
3.2 Configuration
3.2.1 System Setup
In the GUI, use the Configuration => System page to set up, configure and manage your IP. This
page displays basic static information on the system, including contact details, and IP addresses. Default
values and details are provided, which should be modified, by specifying parameter values according to
your network system and requirements.
Changing the name of your WBSn base station
1. Navigate to Configuration => System => General tab.
2. Enter the new name of your base station in the Device Name field.
3. Click Apply.