User Manual
Table Of Contents
- 1. Introduction
- 2. Installation
- 3. Defining and Managing WBSn
- 5. Appendix a: Troubleshooting
- 6. Appendix B: Frequently Asked Questions
- 7. Appendix C: Hardware Specification
- 8. Glossary
WBSn-2450 User Guide Page - 20 -
3.2.3 Specifying the Uniform Time of the Base Station Unit
To specify the Base Station Unit time
1. Navigate to Configuration => System => Time to set a unified time of the unit, according to the
NTP server, and your specific time zone. In the event that there is no active NTP server, the time can
also be set manually.
2. Specify the values of the fields, using the table below.
Parameter Description
NTP Network Time protocol: how to set a unified time across a network
NTP Server Network Time Protocol server, provides for entire network
Manual Time Setting In the event that no NTP server is functioning, use this field to
manually set the time of the base station unit
Time Zone Configuration Specify the appropriate time zone for your geographical location
3.2.4 Specifying the Location of the Base Station Unit