User Manual
Table Of Contents
- 1. Introduction
- 2. Installation
- 3. Defining and Managing WBSn
- 5. Appendix a: Troubleshooting
- 6. Appendix B: Frequently Asked Questions
- 7. Appendix C: Hardware Specification
- 8. Glossary
WBSn-2450 User Guide Page - 25 -
Parameter Description
Type Values:
OUI: Identifies the MAC address by the first three bytes, determining
the Vendor ID
Static: Requires the entire MAC address
Address Prefix Either specify the OUI numbers, or enter the full MAC address
Description The name of device to whom this MAC belongs.
5. Click Apply, and the click Add. The group of MAC addresses is listed in the group table.
3.4.2 Radio Configuration
To Configure Your Radio Settings
1. Navigate to Configuration => Wireless => Radio.
2. Select the required channel bandwidth and specify the parameters, as described in the following
table.
Note: 2.4 GHz and 5.0 GHz are available in WBSn-2450.
Field Description
Radio Specify that the radio modules are operational, or turn
them off for purposes such as maintenance.
Channel Width 20 MHz or 40 MHz for 2.4 GHz
5 MHz, 10 MHz, 20 MHz or 40 MHz for 5.0 GHz
Channel Specify the channel/frequency
TX Power Specify the transmission power according to the regulation
3.5 ACS (Online, Offline)
The Automatic Channel Selection (ACS) utilizes an embedded algorithm to scan for the best channel with
which your base station can work, ensuring optimal capacity, minimal interference and maximum
performance.
Offline ACS performs a full scan of the available channels while the system is down, determining which
channels are the best and most interference-free, and prompting you to choose these channels prior to
resuming and reactivating the system.
Online ACS runs in the background while the system is up, checking the available channels, and
whether any of those available are better for use than the channels currently being utilized.
Note: The Online ACS will be enabled in a future release
To Access Automatic Channel Selection
1. Select Configuration => Wireless => Radio.
2. Expand the required field (Online ACS or Offline ACS) to specify the parameters, described in the
following table.
Parameter Description
Offline ACS
Select Channel button Click to select a specific channel
Scan Click to scan, then define the following parameter values:
• Optimization mode:
o
Throughput