User Manual
Table Of Contents
- 1. Introduction
- 2. Installation
- 3. Defining and Managing WBSn
- 5. Appendix a: Troubleshooting
- 6. Appendix B: Frequently Asked Questions
- 7. Appendix C: Hardware Specification
- 8. Glossary
WBSn-2450 User Guide Page - 31 -
To upgrade firmware using FTP
1. Navigate to Administration => Firmware.
2. In the Upgrade Protocol field, select FTP from the drop-down list. The FTP Server IP field is
automatically populated by the information specified in Configuring an FTP Client
.
3. In the Upgrade File Path (FTP) field, specify the path to the upgrade file provided to you under
separate cover by Wavion.
4. Note: The Upgrade File (HTTP) field is disabled.
5. Click Upgrade. A notification message is displayed, informing you of the expected time that it will
take for the upgrade to be performed.
Proceed directly to Switching to the Upgraded Firmware Version
.
To upgrade firmware using HTTP
1. Navigate to Administration => Firmware.
2. In the Upgrade Protocol field, select HTTP from the drop-down list. The FTP Server IP field is
automatically disabled.
3. In the Upgrade File (HTTP) field, click Browse, and navigate to the path where the upgrade file,
provided to you under separate cover by Wavion, was saved.
4. Note: The Upgrade File Path (FTP) field is disabled.
5. Click Upgrade. A notification message is displayed, informing you of the expected time that it will
take for the upgrade to be performed.
Proceed directly to Switching to the Upgraded Firmware Version
.