Owner's Manual

STOP USE IMMEDIATELY IF A PROBLEM OCCURS. Failure to do so may result in
personal injury or damage to the product. Return it to your authorized Wāvtech dealer.
HAVE AN EXPERT DO THE WIRING AND INSTALLATION. This unit requires special
technical skill and experience for wiring and installation. To insure safety and proper
function, always contact the authorized dealer where you purchased the product to have
it done professionally.
INSTALL THE UNIT SECURELY WITH SPECIFIED PARTS. Be sure to use only the
included parts and specified installation accessories (not included). Use of other than
designated parts may damage this unit. Install the unit securely so that it will not come
loose during a collision or sudden jolt.
ROUTE WIRING AWAY FROM SHARP EDGES AND MOVING PARTS. Arrange cables and
wiring away from sharp or pointed edges and avoid moving parts such as seat hinges or
rails to prevent pinching or wear. Use loom protection where appropriate and always use
a grommet for any wiring routed through metal.
NEVER RUN SYSTEM WIRING OUTSIDE OR UNDERNEATH THE VEHICLE. All wiring
must be routed, secured and protected inside the vehicle. Failure to do so may result in
fire, injury or property damage.
INSTALL THE UNIT IN A DRY AND VENTILATED LOCATION. Avoid mounting locations
where the unit will likely be exposed to high moisture or heat without adequate
ventilation. Moisture penetration or heat buildup may result in product failure.
REDUCE GAIN AND SOURCE VOLUME TO MINIMUM LEVELS FOR INITIAL SYSTEM
TUNING AND BEFORE CONNECTION TO AN AMPLIFIER. Ensure amplifier power is off
before connecting RCA cables and follow proper system gain setting procedures. Failure
to do so may result in damage to the amplifier and/or connected components.
CAUTION
Package Contents:
Main Unit Terminals
Accessories Required for
Installation (not included):
Mounting Tabs
(detachable)
Ÿ RCA Interconnects
Ÿ 18AWG Wire
Ÿ In-line Fuse Holder w/1A fuse
Ÿ Battery Ring Terminal
Ÿ Wire Crimp Connectors
Ÿ Grommets and Loom
Ÿ Cable Ties
Ÿ Mounting Screws
2
PWR/SPK GND
link2