Owner's Manual

Internal Jumper Locations and Settings
While all Wāvtech models provide external controls for main
adjustments, there are also a few internal configuration jumpers
available to resolve certain special vehicle or system conditions. The
linkDQ’s internal jumper locations and default settings are shown in
the illustration below. To access these jumpers, simply remove the two
top screws from each end panel and loosen two bottom screws on one
side in order to easily remove the chassis top cover. It is recommended
to detach the power supply connector first to ensure that the unit is
completely powered off while making any jumper changes.
Notes:
Ÿ Input sensitivity range jumpers (20V/40V) are independent for each
SPK input channel, so may be set differently between channels as
system conditions require.
Ÿ Load bypass jumpers (LOAD) are independent for each SPK input
channel and must be removed or moved to a single pin in order to
disconnect the internal loading from that channel.
Ÿ Both RCA balanced-unbalanced input jumpers (BAL/UNBAL) should
be moved together if changed.
9
50