Instructions / Assembly

Watch and Assemble www.waybasics.com/help-cube Help and Comments www.waybasics.com/contact Share and Win www.waybasics.com/share

Important

Tip Start assembly from bottom to top.

DO NOT place unit on its side or back as

it will compromise its structural integrity.

THIS SIDE UP

WARNING: CHOCKING HAZARD

Small parts NOT for children under 3 years

Carefully remove the 3M

protective layer from adhesive.

Place alignment pins

in vertical zBoards.

Align horizontal zBoard and press ﬁrmly

to secure unit together. Visit links below

for more details.

Enjoy building possibilities!

Fit backboard into horizontal zBoard

groove.

Arrange vertical zBoard with grooves

facing backboard as shown.

Align vertical zBoards to backboard.

1 Backer Board

thin and has no adhesive

2 Horizontal zBoards

with grooves

2 Vertical zBoards

adhesive strips on 2 edges

8 Pins

Included

CUBE

• Assemble your unit on a ﬂat even surface, carpet not recommended

• Furniture is for indoor use only

• When moving your Way Basics furniture, lift from the bottom

• Make sure zBoard surfaces are clean and dry

PAGE 1
CUBE • Assemble your unit on a ﬂat even surface, carpet not recommended • When moving your Way Basics furniture, lift from the bottom • Furniture is for indoor use only • Make sure zBoard surfaces are clean and dry Included 8 Pins 2 Vertical zBoards adhesive strips on 2 edges 1 1 Backer Board thin and has no adhesive Fit backboard into horizontal zBoard groove. 2 Arrange vertical zBoard with grooves facing backboard as shown. 5 Carefully remove the 3M protective layer from adhesive.