Instructions / Assembly

Watch and Assemble www.waybasics.com/help-double-cube-plus Help and Comments www.waybasics.com/contact Share and Win www.waybasics.com/share

Important

Tip Start assembly from bottom to top.

DO NOT place unit on its side or back as

it will compromise its structural integrity.

THIS SIDE UP

1 2 3

5 6

Carefully remove the 3M

protective layer from adhesive.

Place alignment pins

in vertical zBoards.

Align vertical zBoards and

backer board to horizontal

zBoard.

Align middle zBoard.

Align vertical zBoards and

backer board to middle

zBoard.

Align horizontal zBoard. Visit

links below for more details.

Enjoy building possibilities!

2 Backer Boards

thin and has no adhesive

2 Horizontal zBoards

with grooves

4 Vertical zBoards

adhesive strips on 2 edges

16 Pins

1 Middle zBoard

with grooves on 2 sides

WARNING: CHOKING HAZARD

Small parts NOT for children under 3 years

Included

DOUBLE CUBE PLUS

• Assemble your unit on a ﬂat even surface, carpet not recommended

• Furniture is for indoor use only

• When moving your Way Basics furniture, lift from the bottom

• Make sure zBoard surfaces are clean and dry

PAGE 1
DOUBLE CUBE PLUS • Assemble your unit on a ﬂat even surface, carpet not recommended • When moving your Way Basics furniture, lift from the bottom • Furniture is for indoor use only • Make sure zBoard surfaces are clean and dry Included 16 Pins 4 Vertical zBoards adhesive strips on 2 edges 2 Backer Boards thin and has no adhesive 2 Horizontal zBoards 1 Carefully remove the 3M protective layer from adhesive. 4 Align middle zBoard. with grooves 2 Place alignment pins in vertical zBoards.