Instructions / Assembly

Watch and Assemble www.waybasics.com/help-rectangle Help and Comments www.waybasics.com/contact Share and Win www.waybasics.com/share

Important

Tip Start assembly from bottom to top.

DO NOT place unit on its side or back as

it will compromise its structural integrity.

THIS SIDE UP

Carefully remove the 3M protective

layer from adhesive.

Fit backboard into horizontal zBoard

groove.

3 Place alignment pins in vertical zBoards.

5 6

Arrange vertical zBoard with grooves

facing backboard as shown.

Align vertical zBoards to backboard.

Align horizontal zBoard and press ﬁrmly

to secure unit together. Visit links below

for more details.

Enjoy building possibilities!

2 Horizontal zBoards

with grooves

1 Backer Board

thin and has no adhesive

2 Vertical zBoards

adhesive strips on 2 edges

8 Pins

Included

WARNING: CHOKING HAZARD

Small parts NOT for children under 3 years

RECTANGLE

• Assemble your unit on a ﬂat even surface, carpet not recommended

• Furniture is for indoor use only

• When moving your Way Basics furniture, lift from the bottom

• Make sure zBoard surfaces are clean and dry

PAGE 1
RECTANGLE • Assemble your unit on a ﬂat even surface, carpet not recommended • When moving your Way Basics furniture, lift from the bottom • Furniture is for indoor use only • Make sure zBoard surfaces are clean and dry Included 8 Pins 2 Vertical zBoards adhesive strips on 2 edges 1 Backer Board thin and has no adhesive 1 Fit backboard into horizontal zBoard groove. 2 Carefully remove the 3M protective layer from adhesive. 4 Arrange vertical zBoard with grooves facing backboard as shown.