Instructions / Assembly

Watch and Assemble www.waybasics.com/help-door-cube Help and Comments www.waybasics.com/contact Share and Win www.waybasics.com/share

1 2 3

4 5 6

(Press)

Carefully remove the 3M

protective layer from adhesive.

Place alignment pins in vertical

zBoards.

Align vertical zBoards and backer

board to bottom zBoard.

Align top zBoard. Orient door properly as shown and

align bottom pin. Press on spring

loaded top pin and insert.

Join other connect cubes with

connector pins! Visit links below for

more details. Enjoy building possibilities!

Note Use included decals to cover the

connector holes if not stacking cubes.

CONNECT DOOR CUBE

Important

Tip Start assembly from bottom to top.

DO NOT place unit on its side or back as

it will compromise its structural integrity.

THIS SIDE UP

WARNING: CHOKING HAZARD

Small parts NOT for children under 3 years

1 Bottom zBoard

with door pin slot

1 Top zBoard

with magnetic door stopper

2 Vertical zBoards

adhesive strips on 2 edges

8 Alignment Pins

4 connectors pins

1 Backer Board

thin and has no adhesive

1 zBoard Door

Included

• Assemble your unit on a ﬂat even surface, carpet not recommended

• Furniture is for indoor use only

• When moving your Way Basics furniture, lift from the bottom

• Make sure zBoard surfaces are clean and dry

PAGE 1
CONNECT DOOR CUBE • Assemble your unit on a ﬂat even surface, carpet not recommended • When moving your Way Basics furniture, lift from the bottom • Furniture is for indoor use only • Make sure zBoard surfaces are clean and dry Included 8 Alignment Pins 4 connectors pins 2 Vertical zBoards adhesive strips on 2 edges 1 1 Bottom zBoard Carefully remove the 3M protective layer from adhesive. 2 Place alignment pins in vertical zBoards. 3 Align vertical zBoards and backer board to bottom zBoard.