Installation Guide

Watch and Assemble www.waybasics.com/help-open-cube Help and Comments www.waybasics.com/contact Share and Win www.waybasics.com/share
Important
Tip Start assembly from bottom to top.
DO NOT place unit on its side or back as
it will compromise its structural integrity.
THIS SIDE UP
WARNING: CHOCKING HAZARD
Small parts NOT for children under 3 years
1 2 3
4 5
Carefully remove the 3M
protective layer from adhesive.
Place alignment pins
in vertical zBoards.
First fit backer board in groove, then
arrange vertical zBoard with grooves
facing backer board as shown.
Align horizontal zBoard.
Join other connect cubes with connector pins!
Visit links below for more details. Enjoy
building possibilities!
Note Use included decals to cover the
connector holes if not stacking cubes.
1 Backer Board
thin and has no adhesive
2 Horizontal zBoards
with grooves
2 Vertical zBoards
adhesive strips on 2 edges
8 Alignment Pins
4 connectors pins
Included
CONNECT OPEN CUBE
• Assemble your unit on a flat even surface, carpet not recommended
• Furniture is for indoor use only
• When moving your Way Basics furniture, lift from the bottom
• Make sure zBoard surfaces are clean and dry