King Water Filtration Eco System Owner’s Manual Whole Home Municipal and Well Water Treatment Systems Copyright ©2019 Wayde King Water FiltrationTM All rights reserved MADE IN THE USA PURE WATER TECHNOLOGIES, LLC | dba Wayde King Water Filtration™ www.KingWaterFiltration.com | 5502 S. Fort Apache Rd. Suite # 100, Las Vegas, NV 89148 | Customer Service Ph: 855.957.2166 | customerservice@kingwaterfiltration.
Table of Contents IMPORTANT INFORMATION ............................................................................................................... 1 SAFETY PRECAUTION........................................................................................................................ 2 ARRIVAL, UNPACKING, AND INSPECTION, SYSTEM LOCATION ................................................... 3 TYPICAL INSTALLATION AND SYSTEM LOCATION .......................................................................
IMPORTANT INFORMATION Installation must be made within an area protected from the elements and freezing. The unit must be protected from rain, dust, flooding, snow, freezing, and direct sunlight (the system's exposure to direct sunlight may cause algae growth). Failure to comply will void the warranty. • Do not run ½" inside diameter (ID) semi-rigid drain tube more than 20 running feet. If over 20 running feet, increase drain line tubing size to 3/4" ID for the entire length of tube.
SAFETY PRECAUTION Read all instructions, specifications, cautions, and warnings before installing and using your water filter system. Learn the specific details regarding installation and use. Failure to follow them could cause serious property damage. Installation errors can cause property damage. All equipment needs to be plumbed into the water system by a licensed plumber. These guidelines must be followed during system installation: • Use the system on a potable, safe-to-drink, COLD water supply only.
ARRIVAL, UNPACKING, AND INSPECTION • Inspect the carton and water filter for evidence of rough handling and concealed damages. If contents appear damaged, ask driver or contact the carrier for a damage claim form to fill out. Notify shipper immediately. • Remove components from the shipping carton. Check that all installation parts are present, which includes the unit and installation hardware. • Make a complete inspection of the system to ensure that: a.
TYPICAL INSTALLATION AND SYSTEM LOCATION Whole House Water Filter System Installation The system needs to be installed by a licensed plumber in your area. DOWNFLOW WITH BACKWASH WATER FILTER SYSTEMS Unpack the control valve from the shipping box. It is recommended that you keep the original boxes and packing materials PURE WATER TECHNOLOGIES, LLC | dba Wayde King Water Filtration™ www.KingWaterFiltration.com | 5502 S. Fort Apache Rd. Suite # 100, Las Vegas, NV 89148 | Customer Service Ph: 855.957.
MUNICIPAL SYSTEM AUTOMATIC CONTROL VALVE PROGRAMMING Clock MUST be set to 12:01 PM to get into programming mode. Step 1: Press and hold one of the up or down arrows until the clock moves. Set the time to 12:01 PM. Push the Recycle button to set. (recycle button) Step 2: Press and hold the up and down buttons at the same time to get into the Master Programming Mode. A pencil icon lets you know you are in programming mode. The code in the upper left shows the portion of the program being changed.
WELL SYSTEM AUTOMATIC CONTROL VALVE PROGRAMMING Clock MUST be set to 12:01 PM to get into programming mode. Step 1: Press and hold one of the up or down arrows until the clock moves. Set the time to 12:01 PM. Push the Recycle button to set. (recycle button) Step 2: Press and hold the up and down buttons at the same time to get into the Master Programming Mode. A pencil icon lets you know you are in programming mode. The code in the upper left shows the portion of the program being changed.
CONNECTING WATER FILTRATION SYSTEM TO WATER SUPPLY • Turn off the main water shutoff valve. MINIMUM MATERIALS NEEDED • Open all plumbing fixtures in the house including all outside faucets in order to drain the lines of all water. • ¾” or 1” male thread adapters to plumb the system • Wrenches, either open end or adjustable jaw, sized to fit compression adapters • Cut and remove a section of the main incoming water line near where the system is to be installed. Allow this line to drain thoroughly (Fig 8).
TIPS TO AVOID ACCIDENTAL PROPERTY DAMAGE INSTALLING A LEAK DETECTOR VALVE Wayde King Water Filtration Whole Home Filtration and Conditioning Systems use the latest technologies available to ensure and prevent water rupture. However, if manufacturing guidelines are not followed, water damage can occur. Causes of flooding include excessive water pressure, spikes in water pressure, human tampering, and negligent installation.
GUIDE FOR REPLACING MEDIA 1. Turn off the water to the unit and unplug from the power source. 2. Disconnect the unit from your plumbing. 3. Carefully unscrew the control valve off the top of the tank. 4. Remove the riser tube from inside the mineral tank. 5. Lay the tank on its side or lay over a trash can to remove media. 6. Rinse the inside of the tank clean with a garden hose, discard old resin, and save the old gravel. 7. Stand media tank upright.
TROUBLESHOOTING PROBLEM CORRECTION • Re-read the instructions to install the system properly. No water flow • Check the in and out arrows on the bypass valve to ensure the system is not piped backwards. • Make sure the bypass valve is in the “Service” position. Media discharging during backwash • Make sure top distributor has been installed properly. System does not backwash • Control valve not programmed properly. Check programming and re-program as needed.
[DF - GAL] Display Format = Gallons (GAL) Liters [Ltr] and Cubic Meters [Cu] are alternative settings. However, all instructions are written for Gallons. [VT – FLtr] (FOR MUNICIPAL SYSTEMS) Valve Type = Filter (FLtr). [VT - dF 1b] (FOR WELL SYSTEMS) Valve Type; downflow single backwash (dF 1b). [CT - tc] Control Type = “Time Clock” sets the operation of the controller. Backwashing systems are based on time, tc = time clock. [NT --- 1] Number of tanks holding media for treatment.
MEASURING SYSTEM EFFECTIVENESS • Pure refreshing taste • Your hair will feel softer and less dry • Your skin will feel softer and less dry • Soaps will lather more easily • Less detergent in dishwasher when compared to municipal water • Less detergent needed for washing clothes compared to municipal water • Less spotting on dishes when compared to municipal water • Clothes will be whiter and/or more vibrant in color due to the removal of chlorine • The screens in your aerators on faucets and shower heads wi
SHIPPING POLICY Billing Information Your credit card will be billed as “Pure Water Technologies”. Free Shipping Shipping is free for all Continental US orders over $999.99 (excluding Hawaii and Alaska). Canadian Shipments UPS charges you the receiver a brokers fee for any shipment that crosses the US border. Please note UPS is also required in your location to collect GST/VAT on the value of your shipment. Undeliverable Packages Occasionally packages are returned to us as undeliverable.
RETURN POLICY General Return Policy We will accept return of Wayde King Water Filtration brand items if unused and in their original condition within 30 days of delivery for a full refund of your purchase price. Shipping and Brokerage charges are not refundable. Customers are responsible for both delivery and return shipping/freight costs. All returns will be inspected for completeness and damage. Some products have return restrictions.
RETURNS PROCEDURE All returned products will be thoroughly inspected to determine overall condition of item being returned and if it complies with our policies and procedures. Please verify the product you are returning meets the guidelines herein and qualifies for return to avoid any delays, or denial of, processing your return.
PRODUCT WARRANTY INFORMATION 10 Year Warranty Wayde King Water Filtration warrants to the end user (“customer”) that its tanks between (9” - 13” diameter), valves, bypass’s, fittings, housings and all filtration media (“Covered Items”) will be free from defects in material and workmanship under normal use and service for a period of 10 years when used in accordance with our recommendations.
HOW TO SUBMIT A WARRANTY CLAIM KEEP THIS MANUAL FOR FUTURE REFERENCE AND UNIT MAINTENANCE For further assistance visit us at www.KingWaterFiltration.com Online Warranty Information: https://KingWaterFiltration.com/warranty.htm To view the latest edition of the Whole Home Municipal and Well Water Treatment Systems, visit KingWaterFiltration.com Product design is subject to change without notice.