Full Product Manual

PURE WATER TECHNOLOGIES, LLC | dba Wayde King Water Filtration™ www.KingWaterFiltration.com |
5502 S. Fort Apache Rd. Suite # 100, Las Vegas, NV 89148 | Customer Service Ph: 855.957.2166 | [e-mail]
7
CONNECTING WATER FILTRATION SYSTEM TO WATER SUPPLY
• Turn off the main water shutoff valve.
• Open all plumbing fixtures in the house
including all outside faucets in order to
drain the lines of all water.
• Cut and remove a section of the main
incoming water line near where the
system is to be installed. Allow this line
to drain thoroughly (Fig 8).
• If copper piping is used and soldered,
remove the bypass from the valve
assembly and attach your plumbing
adapters to the bypass away from the
valve. This simple step will ensure that
you are not applying heat as you
solder, or pressure as you tighten the
adapters onto the bypass while they
are mounted on the valve body itself.
• Solder a 3” to 5” piece of copper pipe
into Each of the two pipe adapters
away from the valve, then let them cool
before threading each one onto the
yoke or bypass valve (Fig 9).
• Apply thread seal tape onto the male
adapters for the brass bypass valve
when cool, and securely tighten them
to the bypass valve. This is done
before reattaching them onto the rear
of the valve/meter body assembly.
• Close main water supply shutoff valve.
• Open nearest faucet to relieve
pressure and drain plumbing lines.
MINIMUM MATERIALS NEEDED
• ¾” or 1” male thread adapters to plumb
the system
• Wrenches, either open end or
adjustable jaw, sized to fit compression
adapters
• Pipe cutter
• Thread seal tape
• Sandpaper or emery cloth
• Before installing ¾” or 1” fittings to the
inlet and outlet of the bypass valve or
manifold, wrap the threads 3 times
around with thread seal tape. Install ¾”
or 1” fittings.
• Soldering is no longer required to
plumb with copper pipe. Instead, use
¾” or 1” compression fittings. Connect
plumbing as shown below (Fig 10),
choosing appropriate connection for
mechanical/ automatic control valve.
CAUTION: Do not overtighten or
cross-thread.
CAUTION: Install water filter in
direction of arrows.