Use and Care Manual

PURE WATER TECHNOLOGIES, LLC | dba Wayde King Water Filtration™ www.KingWaterFiltration.com |
5502 S. Fort Apache Rd. Suite # 100, Las Vegas, NV 89148 | Customer Service Ph: 855.957.2166 | [e-mail]
3
ARRIVAL, UNPACKING, AND INSPECTION SYSTEM LOCATION
• Inspect the carton and water filter for evidence of rough handling and
concealed damages. If contents appear damaged, ask driver or contact the
carrier for a damage claim form to fill out. Notify shipper immediately.
• Remove components from the shipping carton. Check that all installation
parts are present, which includes the unit and installation hardware.
• Make a complete inspection of the system to ensure that:
a. there are no physical damages to the system,
b. all accessories are present,
c. and the system is clean and dust free.
CHECKLIST
WATER FILTER SYSTEM
• Unpack the water filter from
shipping box.
• Unpack the control valve from
shipping box.
✓
All Point of Entry Whole House
models with backwashing and
backwash programming.
• Check the entire water filter
system for any loss of parts.
• Parts needed to install the water
filter are packaged in a plastic
bag. To avoid loss of the small
parts, keep them packaged until
you are ready to use them. Be
sure not to discard components
hidden in packaging.
✓
✓
All Point of Entry Whole House
models with backwash
programming.
Read all instructions carefully to learn the
details for installing and using your Whole
Home Municipal and Well Water Treatment
System. Failure to follow the Installation and
Operation Guide could cause injury and/or
property damage.
Select the location of your
water filter system with care.
For correct installation refer
to the appropriate diagram.
Various conditions which
contribute to proper location
are as follows:
• Do not locate the system
where the environment
would offer any risk of
water contamination.
• Do not put any liquid other
than water into the
system.
• Position the water filter
near main water supply
line, drain and electrical
outlet.
• Position so that main
water supply shutoff valve
is between water filter and
main water source.
• Turn off the water flow to
the house while installing
system.
• Select location where floor
is level. If floor is rough
and/or uneven, you can
level by placing tanks on
3/4" plywood, and shim to
level as needed.
• Install the water filter by
positioning it BEFORE the
water heater.
• Water temperatures
above 100°F (38°C) will
damage the water filter.
Use on cold water line
only.
• Allow sufficient space
around the installation
area for easy servicing.
• Provide a non-switched
110/120V, 60Hz power
source for the control
valve (automatic system).