Users Manual

Installing your Secure4K
(two options - Direct Wire or OBD-II Power Cord)
1. Locate the OBD-II socket in your vehicle, the upper figure shows some popular places.
2. Insert the OBD-II plug into the OBD-II socket firmly.
NOTE: The OBD-II connector fits only one way into the vehicle’s OBD-II socket, do not force the fit; observe
correct orientation before applying force.
3. Route the wire with USB Type-C plug of the OBD-II Power Cord to the expected camera
mounting location on the windshield.
NOTE: Leave an extra few inches of cord length near the camera to insert the Type-C plug into the Secure4K
Dock, and also to make mounting and dismounting the camera easier.
4. Secure any excess wire after the camera is mounted.
Park the car in a safe and convenient place for the installation
The OBD-II socket
Option A OBD-II Power Cord
Option B Direct Wire Power Cord
1. Install power in the vehicle
1. Turn off the engine and the accessory power.
2. Find the location and layout of your fuse box as well as the appropriate fuse type from the
vehicle’s user manual.
NOTE:
a. Professional installation assistance at a qualified dealer is recommended, if you are not familiar with
identifying fuses in a vehicle and installing power system related items.
b. Please contact [e-mail] for assistance with finding an approved dealer in your area if
you are unsure of where to locate one yourself.
3. Connect the red ACC wire to a switched fuse:
a. A switched fuse is used to monitor the accessory power such as
cigarette lighter, car radio, etc. They will be switched off after you
turn off the car. Identify them by referring to the vehicle user manual
or consulting a qualified professional.
b. Verify the fuse is a switched fuse by using a multimeter to track
voltage within the circuit across ignitions ON and OFF positions.
c. If confirmed as a switched power fuse, remove the identified
switched fuse from the fuse panel. Use the fuse puller tool if available.
d. Remove the sleeve from the end of the red ACC wire, and wrap the
wire around one of the blades of the switched fuse.
e. Reinsert the fuse back into the fuse panel carefully and firmly to ensure the wire remains
secured to the fuse blade.
4. Connect the yellow BATT+ wire to a constant power fuse
a. The constant power fuses are used to monitor constant power within a vehicle. They will
not be switched off after you turn off the car. Identify them by referring to the vehicle manual
or consulting a professional.
5 6