Users Manual

b. Verify the fuse is a constant fuse by a multimeter to track voltage within the circuit across
ignitions ON and OFF positions.
c. If confirmed as a constant power fuse, remove the identified constant fuse from the fuse panel.
Use the fuse puller tool if available.
d. Remove the sleeve from the end of the yellow BATT+ wire and wrap the wire around one of the
blades of the Constant Power fuse.
e. Reinsert the fuse back into the fuse panel carefully and firmly to ensure the wire remains
secured to the fuse blade.
5. Connect the black GND wire to a chassis ground point, such as a bolt, that is directly touching
a bare metal surface of the vehicle’s framework.
6. Route the wire with USB Type-C plug of the Direct Wire Power Cord to the expected camera
mounting location on the windshield.
NOTE: Leave an extra few inches of cord length near the camera to insert the Type-C plug into the Secure4K
Dock, and also to make mounting and dismounting the camera easier.
7. Secure any excess wire after the camera is mounted.
1. Put the Type-C Power Cord into the Power Cord
Locker. Remove the Locker’s gasket if necessary.
2. Remove the Locker’s tape paper.
3. Insert the Type-C plug into the camera Type-C
socket. Push the Locker to ensure glued together
with the camera dock.
4. Seal with Tamp Tape.
5. Turn on the engine, the status LED will illuminate
blue and then turn red if a SD card is inserted.
For optimal performance, please ensure the power cord is firmly and securely fitted into the USB
Type-C Power Connection.
1. Open the Waylens Fleet App and follow the prompts to connect to the Secure4K camera.
2. If can’t find the Secure4K WiFi network, normally is a network with name as Waylens-xxxxx
(DIRECT-Waylens-xxxxx if WiFi Direct is enabled), press Waylens Button to wake up the WiFi.
3. Locate the diagnostic feature in the profile page(Skip Login) or Maintenance(Maintainer Login).
4. After the diagnostic, view the live preview of the camera to assist the placement on the
windshield.
Waylens Fleet App has the diagnostic feature to ensure the power cord connection is right.
3. Diagnostic with Waylens Fleet App
2. Connect power to the Secure4K Dock
7 8