Users Manual

4. Install the Mount Plate on the Windshield 5. Attach the Camera and Dock to the Mount Plate
SAFETY WARNING: Do not place the Secure4K in an area on the windshield where the product
interferes with the driver’s field of vision or other in-vehicle sensors. The Secure4K should be
mounted at the center top of the front windshield, optimizing visibility inside and outside the
vehicle.
NOTE: Do not place camera mount too low on windshield where visibility may be blocked by the vehicle itself,
such as wiper blades or raised hood structures.
1. Without removing the Mount Plate
adhesive cover plastic, position the
Mount with Placement Guide against
the top center of your windshield and
dashboard.
3. Firmly press the Mount Plate to the
windshield glass and hold for 10 seconds.
4. Remove the Placement Guide, leaving
the Mount Plate affixed to the windshield.
2. Verify placement on windshield, then
fold placement guide back away from
glass to remove the plastic cover for the
adhesive
Please be aware that certain films on the windshield glass can affect the night vision quality.
Please ensure the Secure4K is installed properly and firmly attached to the windshield prior to
operating the vehicle. Be sure to make any adjustments to the angle or position of the
Secure4K prior to operating the vehicle.
1. With the Mount Plate attached to the
windshield and the power cord connect-
ed to the Secure4K, position the
Secure4K on the left side of the Mount
Plate. Next, ensure the Mount Plate
locking tabs are aligned with their fittings
on the camera Dock.
2. Slide the camera right to secure it
firmly onto the Mount Plate.
9 10