User's Manual

10
Remote Control
Transmitter
Buttons
Scene 1
Scene 2
Scene 3
Delete
LED’s
Scene 1
Scene 2
Scene 3
Delete





REPLACE Use this procedure to remove a
hand-held remote control transmitter or in-
vehicle mounted transmitter from a Wireless
Gateway scene button.
1. Press and release the DELETE button on the
Wireless Gateway.
All three (3) LED’s on the Wireless Gateway will
turn on.
2. Within five (5) seconds, press and release the
scene button you wish to disconnect from on the
Wireless Gateway.
The selected scene LED will stay lit for 5 seconds
and the other two will turn off.
3. Within five (5) seconds, press the in-vehicle
transmitter or hand-held remote control trans-
mitter button you wish to disconnect from the
Wireless Gateway.
The LED for the selected scene on the Wireless
Gateway will flash three (3) times quickly to
indicate a successful disconnect.
REPLACE Use the following procedure to
remove a single Z-Wave™ device from a
programmed scene. The Wireless Gateway
must not be plugged into AC outlet for this
operation.
1. Press and release the DELETE button on the
Wireless Gateway.
All three (3) LED’s on the Wireless Gateway will
turn on.
2. Within 5 seconds, press the scene button
that is associated with the device you want to
remove.
The selected scene LED will stay lit for 5 seconds
and the other two will turn off.
3. Press and release the Program button on the
Z-Wave™ device you wish to remove.
The LED on the Wireless Gateway will flash three
(3) times quickly to indicate the removal was
Remove Transmitter from Scene
Remove Z-wave™ module from a Scene
Advanced Features
O
N
/
O
F
F
P
R
O
G
.
/
D
I
M
Green LED
on module
Press and Release
Program button
on module

LED’s