User Manual

5
Remove Node from Network and Scene
1. Press the “REMOVE” button. LED will flash. Release.
2. Press the operate button on the Z-Wave node you want to delete
from the network. Release.
3. LED will turn off indicating success.
Factory Reset
1. Press and hold the “COPY” and “RESET” buttons.
2. Hold the buttons until the LED Turns on (about 5 seconds).
3. Release buttons.
4. The LED will flash 10 indicating success.
NOTE: This is a destructive function. All Z-Wave nodes in the
network will have to be reset if this function is used.
Faceplate Installation
1. Place the Room Key Controller into the Wall Bracket. The Faceplate has two
dimples on top which match with two top dimples on the Wall Bracket.
2. Use the two screws provided to secure the Faceplate to the Wall Bracket.
NOTE: The screws fit from the bottom of the Faceplate into the nutserts in the Wall
Bracket.
Regulatory Information
US and Foreign patents pending.
Z-Wave® is a registered trademark of Zen-sys Corporation.
Wayne-Dalton® is a registered trademark of Wayne-Dalton Corporation.
FCC Regulatory Information
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,