Automatic Garage Door Opener OWNER INSTALLATION AND USER MANUAL

Step 6: Mounting Door Bracket

WARNING: Fiberglass, aluminum and

steel doors must be reinforced to prevent

damage to the door. Check with your ga-

rage door manufacturer for their recom-

mendations.

Reinforce light weight doors, as illustrated.

For wood doors, mount door bracket, using two 1/4”-20 x

2” carriage bolts and 1/4” nuts supplied, on center line of

door with middle hole in line with top rollers.

For metal doors, mount door bracket, using two 1/4”-20 x

1/2” self drilling screws supplied, on center line of door

with middle hole in line with top rollers.

Step 7: Installing Light

Remove diffuser cover by pressing on both sides of the bottom of the

lighting cover at the junction of the housing, releasing the locking tabs,

and pulling forward. Screw a 60 Watt bulb (60 Watt Maximum) into

socket. For maximum bulb life, “rough service” bulbs are recom-

mended. Align top and bottom tabs on cover to Motor Power Head Unit

and push straight on until cover locks into place.

Note: light turns on automatically when door is activated and a 4

minute time delay circuit automatically turns light off, allowing am-

ple time to enter the house. A fully open door with light blinking

indicates an obstruction or problems with external safety sensors

during close travel. See trouble shooting section for further details.

Step 8: Installing Wired Wall Station (if included)

WARNING: Install all wall controls out of the

reach of children and in a location where the

door can be seen before activating. Do not

mount wall controls near or next to garage

door.

Wired Wall Station: Wire the garage door opener wall station

using bell wire (low voltage electrical wire) connected to COM

and P.B. on vertical screw terminal strips, as illustrated.

Locate push button adjacent to service entrance door at a

minimum height of 5 ft., and at least 5 ft. away from garage

door (see illustration in Step 10). Fasten the wall station in a

safe location with the (2) Phillips head screws, making sure

not to over tighten. Pilot drill mounting holes

using a 3/32" bit. Additional wired wall stations

may also be installed in accordance with these

instructions.

CAUTION: Over tightening the screws

could deform plastic.