Product Manual

ManualsBrandsWAYNE ManualsSump PumpsWAYNE 12V Battery Powered Thermoplastic Submersible Sump Pump Backup with Automatic Switch

SPECIFICATIONS

AC POWER SUPPLY REQUIREMENTS 120 V

MOTOR

100 W Permanent Magnet DC

DC POWER

12 V Battery

600005W-001 H 03/20

CONSTRUCTION

MOTOR HOUSING Coated Steel

MOTOR SHAFT Stainless Steel

IMPELLER Thermoplastic

VOLUTE Cast Iron

PUMP DISCHARGE 1-1/2 in. NPT

12 Volt Backup Sump Pump

Intended for Indoor Use Only

Please read and save these instructions. Read carefully before attempting to assemble, install,

operate or maintain the product described. Protect yourself and others by observing all safety

information. Failure to comply with instructions could result in personal injury and/or property

damage! Retain instructions for future reference.

Operating Instructions and Parts Manual ESP25n

www.waynepumps.com

PERFORMANCE GAL/HR

Model HP

Discharge Head (Lift Distance)

0 ft 5 ft 10 ft 15 ft

ESP25n 12 V 2700 2100 1500 660

* Battery not included. A Wayne WSB1275 75 Amp

Hour Battery is recommended.

Summary of content (12 pages)

PAGE 1
2 Volt Backup Sump Pump Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for future reference.
PAGE 2
Operating Instructions and Parts Manual DESCRIPTION GENERAL SAFETY INFORMATION The ESP25n is a battery operated backup sump pump. It does not replace a regular pump. It is designed to provide protection in the event household electrical power fails. This system is intended for indoor use only. This pump is intended for use with one 12 V battery. CALIFORNIA PROPOSITION 65 Installation of this pump outdoors, unprotected from the weather, may cause hazardous conditions and will void warranty.
PAGE 3
Operating Instructions and Parts Manual electrician. électricien qualifié. All wiring must be performed by a qualified L'ensemble du câblage doit être effectué par un Do not expose battery to sparks or flame as an explosion or fire could result. Ne pas exposer la batterie à des étincelles ou des flammes. Une explosion ou un incendie pourrait en résulter. Battery acid is corrosive. Avoid spilling on skin or clothing. Eye protection must be worn when handling the battery.
PAGE 4
Operating Instructions and Parts Manual 5. Place the pump with the 4 ft. section of PVC pipe on a solid, level surface in the sump pit on an elevated surface. Avoid dropping metal tools on the battery posts because they may spark or short-circuit the system or battery, causing an explosion. Éviter de faire tomber des objets en métal sur les bornes de la batterie : cela pourrait créer des étincelles ou des courts-circuits du système ou de la batterie, provoquant une explosion.
PAGE 5
Operating Instructions and Parts Manual ESP25n INSTALLATION CONT'D Control Box Installation Method 2 1. Place battery in box, attach red cable to positive battery post and black cable to negative battery post. If a separate, dedicated discharge is not possible as in Method 1, the backup pump can be tied into the AC operated pump's discharge pipe by installing a "Y" connector. Two check valves will be required.
PAGE 6
Operating Instructions and Parts Manual Risk of electrical shock! Use a GFCI receptacle to reduce the risk of fatal electric shock. Cutting the cord will void the warranty and make the pump inoperable. FLOOR JOIST SLOPE PIPE DOWN 1. After installation, the backup pump will start when the water level rises above the backup float switch. "Y" CONNECTOR RIGID PVC PIPE TRANSFORMER Risque de choc électrique! Utiliser une prise avec disjoncteur de fuite à la terre pour réduire le risque de choc électrique.
PAGE 7
Operating Instructions and Parts Manual ESP25n NOTES MAINTENANCE Always disconnect the electrical supply before attempting to install, service or relocate or perform any maintenance. If the power source is out of sight, lock and tag in the open (off) position to prevent unexpected power application. Failure to do so could result in fatal electric shock. Only qualified electricians should repair this unit. Improper repair could result in fatal electric shock.
PAGE 8
Operating Instructions and Parts Manual TROUBLESHOOTING CHART Symptoms Possible Cause(s) Suggested Remedies Pump will not start or run 1. Connections not secure 1. Check all connections 2. Low or defective battery 2. Check battery and replace if low or defective 3. Float switch stuck 3. Make sure nothing is interfering with operation of switch 4. Defective or blown fuse 4. Pull the transformer from the wall outlet and remove. Check internal fuse located inside the control box.
PAGE 9
Operating Instructions and Parts Manual ESP25n For Replacement Parts or Customer Support, Call 1-800-237-0987 Please provide following information: - Model number - Serial number (if any) - Part description and number as shown in parts list Address any correspondence to: Wayne Water Systems 101 Production Drive Harrison, OH 45030 U.S.A.
PAGE 10
NOTES 10
PAGE 11
NOTES ESP25n 11
PAGE 12