Owner`s manual

12 of 46
Copyright 2015 by Southern Pride Distributing, LLC Volume 1
INSTALLATION INSTRUCTIONS
ELECTRICAL INSTRUCTIONS
Electrical Requirements:
 120 volts AC, 60 Hz
 2 wire, single phase
 15 amp required, NEMA 5-15P plug
THE WARRANTY IS VOID IF THE SMOKER IS CONNECTED TO ANY VOLTAGE OTHER
THAN SPECIFIED ABOVE AND ON THE SMOKER DATA PLATE.
Remove all packing material before connecting the electrical and gas supply to the smoker.
 An electrician must provide the conduit and wire for electrical hookup.
 The power is to be left OFF throughout the installation.
 The electrical service is connected via the factory supplied power cord normally located to the rear of the
smoker on the service bay side. Alternatively, the power cord can be removed and the smoker hard wired.
 On models equipped with an optional smoke extractor, the electrician must provide conduit and wire
hookup from the junction box, located on the rear of the smoker, to the exhaust fan. Make the electrical
connections inside the junction box.
NOTE: 125 V.A.C., 1/4 hp maximum connected load, 1100 CFM fan rating recommended for
smokers equipped with the optional smoke extractor damper.
5. If venting or gas connections are to be done at a later time, be sure that the power remains OFF.
Junction box
(Auxiliary power connection)
Smoke extractor
damper
(Optional)
WARNING:
The junction box
is not a power
supply connection.
WARNING:
This appliance, when installed, must be electrically
grounded in accordance with local codes, or in the
absence of local codes, with the National Electrical
Code, ANSI/NFPA 70, or the Canadian Electrical
Code, CSA C22.2, as applicable.
Junction box
(Auxiliary power connection
for smoke extractor exhaust fan)
Shown configured with
right-hand firebox. Con-
nections points are mir-
rored if configured with
left-hand firebox.
Rear View of
Smoker
Smoker extractor damper (Optional)
Power connection
Gas supply
connection
Rear flue
(Optional)