Owner`s manual

34 of 46

MAINTENANCE SCHEDULE (continued)

MONTHLY (continued):

4. Check the Teflon sleeves on the rotisserie wheel stubs (all models except the SPK-1400). Clean or replace

if damaged or worn. Check and tighten the wheel stub bolts and nuts, if needed.

5. Check the product door hinges and the product door latches. Tighten screws and align as needed.

6. For smokers equipped with the optional smoke extractor, the damper inside of the smoke extractor should

be checked for any solids or creosote buildup. To inspect the smoke extractor damper, the damper should

be in the open position and the following steps should be followed:

Reassemble the smoke extractor in the reverse order.

QUARTERLY:

1. Remove the drive system cover and service compartment cover and check the retainer and set screws on

the small and large sprockets. Tighten if needed. All models except the SPK-1400.

2. Scrape creosote buildup off of the firebox side of the baffle board.

Models: MLR-150, SPX-300, SPK-500, MLR-850 and SPK-1000 - From inside of the smoker.

Models: SP-700 and SPK-1400 - From inside of the smoker or through the convection fan access door.

1. Remove 4 bolts

with a 7/16” socket

for access.

2. Pull the damper

assembly out of the

smoke extractor.

3. Inspect the damp-

er for solids or creo-

sote buildup.

Check hinges and

tighten screws as

needed.

Check latch and

align as needed.

View from product

loading doors.

Baffle board.