Please read and save these instructions. Read carefully before attempting to assemble, Protect yourself and others by observing all safety information. Failure ta comply with property dosage! Retain instructions for future reference.
Operating Instructions and Parts Manual installation (Continued) 7. At times, an overload due to overheating, low voltage, jarred impeller, etc. may shut the pump off. Unplug or turn off the pump and wait at least ten minutes. The pump will cool and automatically reset. (Moet PC2 only} 8. Motor should never be operated for more than 2 hours continuously. Critical heating can occur and might severely damage the pump and void warranty. Operation 1.
Maintenance Always disconnect CULVERT pone earn before attempting te install, service, or maintain the pum. IMPELLER REPLACEMENT These parts are designed to handle most clear, nonflammable liquids with slight amounts of abrasives. When impeller vanes become worn from use, or damaged due to pumping abrasive liquids or trash, pump performance will be reduced or prevented altogether. 1. Remove the four cover plate screws holding motor housing and pump housing together.
Operating Instructions and Parts Manual Troubleshooting Cal Symptom Pump will not start Blown fuse LTT TUNE Lf blown, replace with proper sized fuse or reset breaker run 2. Low line voltage . Voltage of power supply must match the voltage of the pump 3. Worn brushes . Replace brushes 4. Impeller blocked . Remove blockage 5. Motor has overheated . Disconnect from power supply and allow to cool (Min, 10 {Model PC2 only) minutes} Pump will not prime or 1. Air leak in suction line 1.
PCY and PC2 Series For Replacement Parts, call 1-800-237-0987 Ea Please provide following information: ENCL) PCY [4%4 LA -Model number 1 Brush and Impeller Kit B6062-WYN1 B BOSS-WYN1 -Part description and number as shown A. impeller 1 in parts list 8. Gasket 2 C. Shaft Seal 1 Address parts correspondence to! NER Wayne Water Systems > heralding Ring ; 100 Production Drive Harrison, OH 45030 USA. 2 impeller Kit B660S9-WYN1T H6053-WYN1 A. Impeller 1 B. Gasket 2 €. Shaft Seal 1 0. Retaining Ring 1 3.
Operating instructions and Parts Manual Limited Warranty For one year from the date of purchase, Wayne Water Systems {"Wayne”) will repair or replace, at its option, for the original purchaser any part or parts of its Sump Pumps or Water Pumps (“Product”) found upon examination by Wayne to be defective in materials or workmanship. Please call Wayne (800-237-0987) for instructions or see your dealer. Be prepared 16 provide the model number when exercising this warranty.
