WayteQ GPS Navigation x880 User Manual English Version
Thanks for using WAYTEQ products ! WAYTEQ reserves the rights of final interpretation of the manual. The product is subject to change without any further notice. Please accept our apology for your inconvenience. Please back up your information in the GPS navigator. WAYTEQ assumes no responsibility for any loss caused by material loss. The manual might contain a few mistakes though it has been checked. If mistakes are found, please contact the WAYTEQ customer service center.
Welcome! Thanks for using the WAYTEQ GPS featured with navigation as the major function as well as other amusement functions like audio play, video play, photo browsing, e-book reading, and games, etc.
Basic Introduction 1. Overview A. Charging Indication B. Speaker C. Power D. 3.5mm Earphone Socket E. Memory Card Slot F. Mini USB G. Stylus Pen Slot H. Battery I. Warranty label 2. Charging by AC Adapter Caution: The charging indicator light is red during charging. Do not unplug the charge until the battery is fully charged and the indicator light turns green. Please charge the GPS navigator when the battery is low or used up in succeeding use. 3.
4. Battery Caution: The GPS navigator adopts removable Li-polymer battery. To avoid battery rupture, explosion, release of hazardous substance or burn, do not unpack, pierce, strike on or discard the battery in fire or water. The navigator has a working temperature of 0~50°C and storage temperature -10~60°C. Do not expose the device in excessive heat or hot areas, for example in the car under strong sunlight. To avoid damaging the device, keep it away from direct sunlight.
Tap the “Turn off” button to turn the unit off. Tap the “Sleep” button to enter a suspend state and the system stops operation. Tap the “Cancel” button to turn back to the screen. 2. GPS Navigation Double tap the “GPS” icon to start navigation program. Caution: Please refer to navigation software instructions for details. In case you bought the device bundled with Sygic navigation software you find the user's manual.pdf in the "Manuals" folder of the built-in memory of the device. 3.
Double tap icon “ Tap the icon “ ” to choose music file . “ for single selection , tap the icon “ delete , tap the icon “ ” “ to select all , tap the icon “ “ for single to delete all. 4. Photo Tap the " " icon, then tap the icon “ “ to select photo files , double tap the photo file to see the following interface . A. Return to the Main menu B. Select photo file C. Slide mode D. Rotate E. Zoom in F. Zoom out G. Next H.
5. Video Tap the icon " " icon, then tap the “ “ icon to choose video files , and double tap the file and enter into following interface . A. Return to the Main menu B. Volume C. Select video file D. Stop E. Next F. Pause/play G. Previous H. Speed bar Tips: Double tap the screen, it will display in full screen, double tap the screen again, it will return to original playing size. 6. Flash Tap the icon “ ” and enter into the following interface . A. Volume D. Stop B. Return to the Main menu E.
7. Ebook Tap the " " icon , then tap the " " icon to choose Ebook files , double tap the file and enter into the following interface . A. Return to the Main menu B. Bookmark list C. Bookmark D. Setting to set theme & font E. Next page F. Previous page G. Select EBook files 8. Setting Tap the " " icon and enter into the following interface .
1. Volume Tap the icon “ ” on the menu and enter into the following interface . Choose “ Music “ files to be background sound when unit is power on . Tips : after make any changes of setting , tap " " to save the change . 2. Backlight Tap the " " icon and enter into the following interface to make the backlight settings. 3. Language Tap the " " icon and choose the language .
4. Date and Time Tap the icon " " and enter into the following interface to set date , time and time zone . 5. Calibration Tap the " " icon and enter into the following interface . Tap the icon "OK" to adjust the touch screen.
6. Explorer Tap icon, there will be one prompt as below to ask if go into WINCE mode, choose “OK” to enter and “Cancel” to exit. 7. Sys Info Tap the " " icon and the system information will be shown. 8. USB Tap the icon “ ” to set the USB working mode .
9. Nav Path Tap the " " icon and enter into the following display interface . When you have several Navigation maps in the device, you can set up one of Navigation maps (navigation program files) by choosing the "Navigation" icon and selecting the Auto Run Navigation , next time when tapping the “GPS” icon in the main menu, the device will run the selected Navigation software automatically . 10. Default Tap the " " icon and enter into the following interface .
12. Resource Tap “ ” icon to enter System Resource interface as shown below. You may check the capacity of the memory, SD card and flash, or tap to clear the memory . 13. Theme Tap “ ” icon to enter the Theme interface as below to set a style and theme for the system interfaces. To rearrange icons at will, tap on an icon and stay until a four-way arrow appears at the upper left of it, drag the icon to a wanted place. 14. Wallpaper Tap icon to enter into the Wallpaper interface as below.
You may choose an pre-installed wallpaper, you may also set an external image as the wallpaper. The pre-installed wallpapers cannot be deleted, while the added images can be deleted. To delete images, select an added image from the “Wallpaper ” interface and then tap . 9. Calculator Tap “ ” icon to enter into the Calculator interface. 10. Unit Tap “ ” icon to enter into the Unit Converter interface. 11. Gobang Tap icon to enter into the game interface. Tap “Start” to start. 12.
This document is for guidance only and does not form part of any contract, and may be subject to change without notice.
