WayteQ GPS Navigation X960BT User Manual English Version
English Thanks for using WAYTEQ products ! z WAYTEQ reserves the rights of final interpretation of the manual. z The product is subject to change without any further notice. Please accept our apology for your inconvenience. z Please back up your information in the GPS navigator. WAYTEQ assumes no responsibility for any loss caused by material loss. z The manual might contain a few mistakes though it has been checked. If mistakes are found, please contact the WAYTEQ customer service center.
English Welcome! Thanks for using the WAYTEQ GPS featured with navigation as the major function as well as other amusement functions like audio play, video play, photo browsing, e-book reading, and games, etc.
English Basic Introduction 1. Overview A. Charging Indication G. Stylus Pen Slot B. Speaker H. Reset C. Power I. MIC D. 3.5mm Earphone Socket J. Light Sensor E. Memory Card Slot K. Warranty label F. Mini USB 2. Charging by AC Adapter Caution: The charging indicator light is red during charging. Do not unplug the charge until the battery is fully charged and the indicator light turns green. Please charge the GPS navigator when the battery is low or used up in succeeding use. 3.
English 4. Battery The navigator has a working temperature of 0~50°C and storage temperature -10~60°C. Do not expose the device in excessive heat or hot areas, for example in the car under strong sunlight. To avoid damaging the device, keep it away from direct sunlight. Follow local regulations while disposing the battery. 5. Install the Car Cradle and Bracket Caution: Do not place the GPS navigator in positions obstructing the driver’s vision, for example at the steering wheel, pedal or gear lever.
English Long press the “Power” button again to enter into the below interface : Tap the “Turn off” button to turn the unit off. Tap the “Sleep” button to enter a suspend state and the system stops operation. Tap the “Cancel” button to turn back to the screen. 2. GPS Navigation Double tap the “GPS” icon to start navigation program. Caution: Please refer to navigation software instructions for details.
English Double tap icon “ Tap the icon “ ” to choose music file . “ for single selection , tap the icon “ delete , tap the icon “ ” “ to select all , tap the icon “ “ for single to delete all. 4. Photo Tap the " " icon, then tap the icon “ “ to select photo files , double tap the photo file to see the following interface . A. Return to main menu E. Zoom in B. Select photo file F. Zoom out C. Slide mode G. Next D. Rotate H.
English 5. Video Tap the icon " " icon, then tap the “ “ icon to choose video files , and double tap the file and enter into following interface . A. Return to main menu E. Next B. Volume F. Pause / Play C. Select video file G. Previous D. Stop H. Speed bar Tips: Double tap the screen, it will display in full screen, double tap the screen again, it will return to original playing size. 6. Flash Tap the icon “ ” and enter into the following interface . A. Volume D. Stop B.
English 7. Ebook Tap the " " icon , then tap the " " icon to choose Ebook files , double tap the file and enter into the following interface . A. Return to main menu E. Next page B. Bookmark list F. Previous page C. Bookmark G. Select Ebook file D. Setting to set theme & font 8. Bluetooth Before using this function, make sure that Bluetooth function of the cell phone has been enabled. Tap the Bluetooth icon to enter the Bluetooth Interface as follows. 8.
English Meanwhile, press the icon “Search audio device” or similar one on the mobile phone. After the mobile phone finds and display the name of the navigator (i.e. PND), tap “Connect” and input the default PIN code: 8888. After pairing, the following interface will be displayed with connection situation and mobile phone name on the bottom. 8.2 Make Calls Tap on the Bluetooth interface to enter the keypad interface as follows.
English To make a call, input the number to call and tap Tap as shown below. to hang off the call. After the call is put through, the following interface will be displayed.
English 8.3 Answer Calls When there is an incoming call, the following interface will be displayed. 8.4 Dial Record Tap in the Bluetooth interface to enter the call records interface as shown below.
English 8.5 Redial Tap icon to redial the latest dialed number. 8.6 Setting Tap icon to enter into the setting interface as shown below. The device’s display name in the Bluetooth transmission process Tap keyboard icon Tap / to set a pin code for the connection to select a ring tone You may choose to “Keep Bluetooth function when the Bluetooth interface is closed” by ticking in the box. Otherwise, the Bluetooth function will be disabled.
English 8.7 Paired Device List Tap the icon to enter into the Paired Device List interface as follows.
English Tap to prompt the GPRS Dial-Up Networking interface as shown below. You may add, modify or delete the operator information. Tap to prompt the following interface. For example, select “Modify Info”, and tap “OK” to go to the interface as shown below. Tap in a column, enter information with the prompted input panel . Tap “OK” to save the input information or tap “Cancel” to quit.
English Tap to connect the navigator to the network. After connection is established, the Internet Explorer interface will prompt as shown below. 8.8 Search Bluetooth Device Tap icon to enter into the Search Bluetooth Device interface for auto Bluetooth device searching and display as shown below. Search / Stop Search for Bluetooth devices; tap it again to stop search Pair Select a Bluetooth device, tap this icon to pair the navigator and the mobile phone.
English 8.9 Phonebooks Tap the icon to enter into the Phonebook interface as follows: Download Download the phonebook of the mobile phone to the PND Dial Select a number from the phonebook and tap this icon to make a call Delete Select a number from the phonebook and tap this icon to delete it 9. FM Setting Tap the " " icon and enter into the following display interface. Tap "+"or "-" icon to increase or decrease the emissive frequency of FM.
English 10. Default Tap the " " icon and enter into the following interface . Tap the icon “ OK “ to load factory default setting . 11. Explorer Tap " " icon, there will be one prompt as below to ask if go into WINCE mode, choose “OK” to enter and “Cancel” to exit. WayteQ do not take responsibility for any operation done on Windows CE interface. 12. Theme Tap “ ” icon to enter the Theme interface as below to set a style and theme for the system interfaces.
English 13. Wallpaper Tap “ ” icon to enter into the Wallpaper interface as below. You may choose an pre-installed wallpaper, you may also set an external image as the wallpaper. The pre-installed wallpapers cannot be deleted, while the added images can be deleted. To delete images, select an added image from the “Wallpaper ” interface and then tap “ ”. 14. GPS Info Tap the " Tap " " icon and the unit will show the detail information of GPS satellites.
English 15. Resource Tap “ ” icon to enter System Resource interface as shown below. You may check the capacity of the memory, SD card and flash. 16. Volume Tap the icon “ ” on the menu and enter into the following interface . Choose “ Music “ files to be background sound when unit is power on . 17. Backlight Tap the " " icon and enter into the following interface to make the backlight settings.
English 18. Language Tap the " " icon and choose the language . 19. Date and Time Tap the icon " " and enter into the following interface to set date, time and time zone . 20. Calibration Tap the " " icon and enter into the following interface. Tap the icon "OK" to adjust the touch screen.
English 21. Sys Info Tap the " " icon and the system information will be shown. 22. USB Tap the icon “ ” to set the USB working mode . 23. Nav Path Tap the " " icon and enter into the following display interface .
English 24. Calculator Tap “ ” icon to enter into the Calculator interface. 25. Unit Tap “ ” icon to enter into the Unit Converter interface. 26. Jaw Breaker Tap “ ” icon to enter into the game interface. Tap “New Game” to start. 27. Russia Block Tap “ ” icon to enter into the game interface. Tap “Start” to start. 28. Dui Dui Peng Tap “ ” icon to enter into the game interface. Tap “New Game” to start. 29. Snake Tap “ ” icon to enter into the game interface and start playing. 30.
