User Manual

Shenzhen Waytronic Electronics Co., Ltd. MicroSound V16.02
5.2 Installation method
1) Can hung on the bracket or flat screw through a mounting hole on the back.
2) Can use binding tape to fix it on the column through the middle of hole at the back.
3) Can use double-sided adhesive tape or glue to stick on the wall or other flat surface.
6. Button function introduction
Button A: after switch on, short press is to trigger to play the recording voice. 3 seconds later after finishing the
recording voice play, only short press again and it can play again. It is invalid to long press.
Button B: after switch on, long press button A for 3 seconds, starting to record after a dropping sound. Then
short press button A again to stop recording, two dropping sounds. If there is distortion, please keep a little further
from the voice source or turn down the volume, recording again.
7. Induction triggering
After switch on and finishing recording, after initial power up, 10~25S later it can trigger to play. After playing for
3s, it will trigger again.
8. Product List
No.
Name
Quantity
Remark
1
Main body
1
Standard configuration
2
Packaging box
1
Standard configuration
3
Packaging bag
1
Standard configuration
4
AAA battery(1.5V)
3
Optional configuration
5
One shelf and one hanger for a set
1
Optional configuration
Product name
Version
Introduction
Remark
MicroSound
series of voice
prompters
(built-in 8ohm
0.5W speaker)
Light/ body induction
(WTV020-S)
Replace voice via USB downloader. Built-in SPI
FLASH can support 64Mbit (standard 8Mbit) at
most for voice memory. Voice length can not
exceed 2000s.
Small and
exquisite, easy
to carry and
install.
Light/ body induction
(OTP)
Can not replace voice. Two levels of volume can
be adjusted. Biggest voice length is 35s, 65s,
80s.
Light/ body induction
(WT5001)
Support SD card for voice replacement. Can
save even power off. Built-in SPI FLASH can
support 64Mbit(standard 16Mbit) at most for
voice memory. Built in 8ohm 1W speaker.
Body induction and
direction identification
Can identify the direction of movement. Can set
voice in different direction
Note:
1. WTV020-Sversion support WAV audio with 6-22Ksample rate.
2. WT5001 version support mp3 format. The bit rate is 16-320Kbps.