Owner`s manual

Page 10

If the Three Digit Code did not work, try this

Auto-Search Method

The Auto-Search Method is a way you can scan

through all of the codes in the table to find the right

code for your component.

STEP 1: Manually or using your old remote, turn on

the component you want to program—for example, to

program your TV, turn on your TV set.

STEP 2: On the URC-SR3, press the Component

button that you want to program (in this case the

button that says TV) and the SELECT [SEL] button at

the same time. Hold down both buttons for 2 seconds

until the TV Component button light turns on. This

signals that you are in programming mode.

IMPORTANT: You have 30 seconds to perform the

next step while you are in programming mode. If you

do not press a button within 30 seconds, the

component LED light will turn off. The remote will exit

the programming mode and you will have to start

over.

STEP 3: Point the URC-SR3 remote control toward

the component and press the UP



arrow (or

DOWN



arrow) button once. Each time the UP



or DOWN



arrow button is pressed, the code will

count up (or down) one code number and send a

Power OFF signal. When the correct code is sent

out, the component will turn off.

DOWN



ARROW



ARROW