Owner`s manual

Page 12
If Auto Search did not work, try this:
Programming URC-SR3
using the Learning Method
STEP 1: Line up the URC-SR3 to the remote control
you want to ‘learn’ from, head--to--head as shown
below. Make sure the heads are one to two inches
apart.
STEP 2: On the URC-SR3, press the Component
button that you want to program (in this case the
button that says TV) and the ENTER [ENT] button at
the same time. Hold down both buttons for 2
seconds until the TV Component button light turns on.
This signals that you are in programming mode.
IMPORTANT: You have 30 seconds to perform the
next step while you are in programming mode. If you
do not press a button within 30 seconds, the
component LED light will turn off. The remote will exit
the programming mode and you will have to start
over.
STEP 3: Press any button on the URC-SR3 that you
want to teach a command to. For example, if you
want to teach the MUTE button on the URC-SR3 the
TV Mute command from the other remote, first press
the MUTE button on the URC-SR3 and the TV
component button LED light will blink once indicating
that the URC-SR3 is ready to learn the command.
STEP 4: Press and hold the MUTE button on the
other remote until the component button LED on the
URC-SR3 blinks twice. Now you can continue
learning all other buttons from your old remote by
pressing the next button on the URC-SR3 and
repeating this step.
Note: The component LED will blink five times if
there was an error in the learning process. In this
case, please repeat Steps 3 and 4.