Owner`s manual

Page 21

Channel Control “Punch Through”

This “Punch Through” enables you to program the

URC-SR3 so that either the Cable or TV Channel

Controls (CH+, CH-, LAST, CHANNEL NUMBERS

0~9, -/--, and ENT) will also operate in other

component modes on the remote control.

STEP 1: Press and hold the component button you

want to add channel control to, such as DVD, and

the SELECT [SEL] button at the same time for two

seconds until the Component LED light turns on.

IMPORTANT: You have 30 seconds to perform the

next step while you are in programming mode. If you

do not press a button within 30 seconds, the

component LED light will turn off. The remote will exit

the programming mode and you will have to start

over.

STEP 2: Press the CH

ANNEL UP

button. The

component LED light will blink once.

SELECT

STEP 3: Press either the TV or CBL/SAT button that

you want to use as the source of channel control.

The component LED will blink two times to confirm it

is saved.

COMPONENT

BUTTONS

