Owner`s manual

Page 22
Transport Control “Punch Through”
This “Punch Through” enables you to program the
URC-SR3 so that DVD/DVR/VCR Transport Controls
(PLAY, STOP, FF, REW, PAUSE, SKIP and RECORD)
will also operate in other component modes on the
remote control.
STEP 1: Press and hold the component button you
want to add Transport Control to, such as CBL or TV,
and the SELECT [SEL] button at the same time for two
seconds until the Component LED light turns on.
IMPORTANT: You have 30 seconds to perform the
next step while you are in programming mode. If you
do not press a button within 30 seconds, the
component LED light will turn off. The remote will exit
the programming mode and you will have to start
over.
STEP 2: Press the PLAY button. The component LED
light will blink once.
SELECT
COMPONENT
BUTTONS
PLAY
STEP 3: Press either the DVD button that you want
to use as the source of Transport Control. The
component LED will blink two times to confirm it is
saved.