Owner`s manual

Page 23

OSD (On-Screen Display) Control “Punch

Through”

This “Punch Through” enables you to program the

URC-SR3 so that CBL/SAT or DVD/DVR/VCR OSD

Controls (GUIDE, MENU, INFO, EXIT, My Button, Sel

and 4 Cursor Controls) will also operate in other

component modes on the remote control.

STEP 1: Press and hold the component button you

want to add OSD Control to, such as TV or DVD, and

the SELECT [SEL] button at the same time for two

seconds until the Component LED light turns on.

IMPORTANT: You have 30 seconds to perform the

next step while you are in programming mode. If you

do not press a button within 30 seconds, the

component LED light will turn off. The remote will exit

the programming mode and you will have to start

over.

STEP 2: Press the MENU button. The component

LED will blink once.

STEP 3: Press either the CBL/SAT or DVD button

that you want to use as the source of OSD Control.

The component LED will blink two times to confirm it

is saved.

SELECT

COMPONENT

BUTTONS