Owner`s manual

Page 24
Erasing Commands -- Overview
You can erase a single learned command, all
learned commands in each component mode,
SimpleSound programming, MacroPower commands,
or re--set the remote to original factory default
settings.
Erasing a Single Learned Command from
One Component
STEP 1: Press the component button where the
learned command is stored and the ENTER buttons
at the same time for two seconds until the component
LED light turns on.
IMPORTANT: You have 30 seconds to perform the
next step while you are in programming mode. If you
do not press a button within 30 seconds, the
component LED light will turn off. The remote will exit
the programming mode and you will have to start
over.
ENTER
STEP 2: Press and hold the button you want to erase
for two seconds. The component LED light will blink
twice to confirm the erasure.
STEP 3: Repeat Step 2 to erase any other buttons in
the selected component mode.
STEP 4: To exit Erase mode, press and hold both the
component button and the ENTER (ENT) button at the
same time until the component LED light blinks three
times.
COMPONENT
BUTTONS