Owner`s manual

Page 29
Finding a Component’s
Set-up Code Number
If you used the Auto--Search or Learning Methods to
program a component, you may not know the code
number you programmed. Here is a way for you to
identify what that code number is, so you can make
a note in the back of this Manual for future reference.
STEP 1: Press the component button you would like
to verify and the SELECT [SEL] button at the same
time for 2 seconds until the selected component LED
light turns on.
IMPORTANT: You have 30 seconds to perform the
next step while you are in programming mode. If you
do not press a button within 30 seconds, the
component LED light will turn off. The remote will exit
the programming mode and you will have to start
over.
COMPONENT
BUTTONS
SELECT
STEP 2: Press the INFO button and count the
number of times the Component LED light blinks. This
number indicates the first digit of the code. Next it
will pause for about one second and begin blinking
again to indicate the number of the second digit.
Then once again it will pause, then blink, to indicate
the number of the third digit.
Example: One blink, pause, eight blinks, pause,
three blinks indicates code number 183.
Note that ten (10) blinks represent the number 0.
INFO