Owner`s manual

Page 8
IF QUICK SET-UP DID NOT WORK, TRY THIS NEXT:
Three-Digit Code Set-Up Method
STEP 1: Find the 3-digit code numbers assigned to
your brand from the lists in the back of this manual.
The codes are listed by component category (i.e.,
CBL/SAT, TV, DVD/DVR, etc.), then by brand name.
For instance, if you would like to locate a code for a
Sony television, first locate the TV category and then
look for the Sony brand.
STEP 2: Once you have located the 3-digit codes
for each of the components that you wish to operate
with your URC-SR3, write them ALL down on a piece
of paper. It’s important that you write down all the
codes listed for your brand because only one code is
going to work with your component.
STEP 3: Manually or using your old remote, turn on
the component you want to program—for example,
to program your TV turn on your TV set.
STEP 4: On the URC-SR3, press the Component
button that you want to program (in this case the
button that says TV) and the SELECT [SEL] button at
the same time. Hold down both buttons for 2
seconds until the TV Component LED light turns on.
This signals that you are in programming mode.
IMPORTANT: You have 30 seconds to perform the
next step while you are in programming mode. If you
do not press a button within 30 seconds,the
component LED light will turn off. The remote will exit
the programming mode and you will have to start
over.
COMPONENT
BUTTONS
SELECT
BUTTON