MSDS

Page 1 of 5
Safety Data Sheet
1 - Identification
Product Name: WD-40 Rust Release Specialist
Penetrant Spray
Product Use: Cleaner, Lubricant
Restrictions on Use: None identified
SDS Date Of Preparation: 07/17/2014
Manufacturer: WD-40 Company
Address: 1061 Cudahy Place (92110)
P.O. Box 80607
San Diego, California, USA
92138 –0607
Telephone:
Emergency only: 1-888-324-7596 (PROSAR)
Information: 1-888-324-7596
Chemical Spills: 1-800-424-9300 (Chemtrec)
1-703-527-3887 (International Calls)
2 – Hazards Identification
Hazcom 2012/GHS Classification:
Flammable Aerosol Category 1
Gas Under Pressure: Compressed Gas
Aspiration Toxicity Category 1
Note: This product is a consumer product and is labeled in accordance with the US Consumer Product
Safety Commission regulations which take precedence over OSHA Hazard Communication labeling. The
actual container label will not include the label elements below. The labeling below applies to
industrial/professional products.
Label Elements:
DANGER!
Extremely Flammable Aerosol.
Contains gas under pressure; may explode if heated.
May be fatal if swallowed and enters airways.
Prevention
Keep away from heat, sparks, open flames, hot surfaces – No smoking.
Do not spray on an open flame or other ignition source.
Pressurized container: Do not pierce or burn, even after use.
Response
IF SWALLOWED: Immediately call a POISON CENTER or physician. Do NOT induce vomiting.
Storage
Store locked up.
Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F. Store in a well-ventilated place.
Disposal
Dispose of contents and container in accordance with local and national regulations.
3 - Composition/Information on Ingredients
Ingredient
CAS #
Weight Percent
US Hazcom 2012/ GHS
Classification
LVP Petroleum Solvent
64742-47-8
50-70
Aspiration Toxicity Category 1
Petroleum Solvent
64742-47-8
20-40
Flammable Liquid Category 3