Installation Instructions

Using the FM Radio
Your speaker can receive FM radio broadcasts.
To do so, follow these steps:
1. Turn the speaker on.
2. Press the Power button to cycle through modes
(USB/Memory Card/BT/Aux In/FM) until you reach FM
mode.
3. The FM antenna will scan for stations automatically
in FM mode.
4. Searching all the stations will take a few minutes.
Once all of the stations are scanned, they are stored
into memory automatically.
5. Press - or + to skip through selected stations.
6. Press and hold + to increase the volume, or press
and hold - to decrease the volume.
For better reception, plug the micro USB
connector of the included FM Antenna Cable
into the DC 5V/ANT micro USB port of the
.rekaeps
When listening to the FM radio:
Tune to a lower preset station Press –
Tune to a higher preset station Press +
Decrease the volume level Hold –
Increase the volume level Hold +
Switch between USB, Card, BT, Aux In,
and FM modes
Press the Power button
LED Indicator Light
The Bluetooth speaker has an indicator light
positioned just above the DC 5V charging port
on the side. The light changes to indicate status
differences, as stated below.
Naxa Electronics Page 6
Power On
BT Pairing
BT Connected
Low Battery
Charging Complete
Charging in Progress
Solid blue light
Blinking blue light
Solid blue light
Blinking red light
No light
Solid red light