Installation Guide

©2015 KNAACK LLC
2
TOOLS REQUIRED
PARTS LIST
(8) 5/16-18
Blind Fastener
(1)
Installation Tool
(2) 5/16-18 x 2-1/4"
Hex Head Bolt
(8) 5/16-18 x 1-1/4"
Hex Head Bolt
(1) 5/16-18 x 2-1/4"
Black Oxide Bolt
(1)
Retaining Washer
(10) 5/16"
Flat Washer
(2)
Fender Washer
(1) 5/16-18
Nylon Lock Nut
(1) 3/4"
Round Cap Plug
(2) Leg
(8) 5/16"
Lock Washer (1) Small Parts Tray (2) Key (2) Mounting Clamp
(1) Side to Cross Box
Mounting Angle (1) “J” Bolt Rubber Mounting Pads
ALUMINUM BED UPFIT KIT PARTS LIST - 32-0243
• Deep Well Ratchet Wrench - 1/2"
• Open or Box End Wrench - 1/2", 9/16"
• Electric Drill
• Bits: 3/16", 3/8", 1/2"
• Carpenter’s Square
(4)
Vinyl Tape
(1)
Zinc Rich Primer
(8) 1/2" x 1"
Plastic Washer
(4) 11/32" x 7/8"
Plastic Washer
(8) 5/16" x 3/4"
Plastic Washer
Note: The rubber mounting pad
comes as a single piece and must be
separated into two pieces, one for
each side of the truck.
BLIND FASTENER INSTALLATION
Place a drop of oil on black oxide bolt for lubrication before assembling.
Place the Blind Fastener in the hole and use 1/2" or 7/16" wrench to
tighten black oxide bolt until fastener is fully seated (it will start out hard
and get easier as fastener “bulbs” out).
Make sure the Blind Fastener and Installation Tool do not turn during
installation.
Black Oxide Bolt
Flat Washer
9/16" Wrench
Installation Tool
Blind Fastener
ALUMINUM TRUCK BED INSTALLATION
Coat drilled holes with Zinc Rich Primer. Insert Blind Fastener through one
1/2" x 1" plastic washer. Insert Blind Fastener into drilled hole. Place
second 1/2" x 1" plastic washer through the bottom of the Blind Fastener.
Continue following installation instructions above to install Blind Fasteners.