Assembly Instructions

Page 14
V
T
SLIDE FRONT X-MEMBER REAR TO CAPTURE TUBE
SLIDE FRONT X-MEMBER FORWARD TO CLEAR TUBE
STEP 8- INSTALL REAR DRIVE TUBE
Torque to 17 ft-lbs
STEP 9- INSTALL REAR COUPLING
USING 2-5/16X1-3/4" BOLTS, 4-5/16" WASHERS, AND 2-5/16" NYLON LOCK NUTS,
INSTALL THE DRIVE TUBE TO THE REAR DROP DOWN MECHANISM. ROTATE AND
POSITION TUBE UNTIL ALL 4 MOUNTING HOLES LINE UP AND TORQUE NUTS TO 17 FT-LBS.
INSTALL THE REAR COUPLING TO THE DRIVE TUBE USING THE COUPLING BUSHING AND CLEVIS PIN.
THE COUPLING SHOULD BE INSTALLED SO THAT IT MAY ROTATE WITH THE RED CAP ON TOP
KNAACK L.L.C.
CONFIDENTIAL, PRINTED
COPIES ARE NOT TO BE
REMOVED FROM SITE
WITHOUT WRITTEN CONSENT.
THIRD ANGLE PROTECION
FORMAT
SW
PAGE NUMBER
SCALE:
DATE:
DRAWN BY:
PART NAME:
MATERIAL:
TOLERANCES=
(EXCEPT AS NOTED)
ANGULAR
±1°
LINEAR
±.031
=CONTROL DIMENSION
1:24
2291-3-01 INSTALL 3
PAGE OF
1914
PART NUMBER: REV.
REV.
PART NUMBER:
STEP 9 - INSTALL REAR DRIVE TUBE
Using 2-5/16x1-3/4” bolts, 4-5/16”
washers, and 2-5/16” nylon lock nuts,
install the drive tube to the rear drop down
mechanism. Rotate and position tube until
all 4 mounting holes line up and torque nuts
to 17 ft-lbs.
V
T
SLIDE FRONT X-MEMBER REAR TO CAPTURE TUBE
SLIDE FRONT X-MEMBER FORWARD TO CLEAR TUBE
STEP 8- INSTALL REAR DRIVE TUBE
Torque to 17 ft-lbs
STEP 9- INSTALL REAR COUPLING
USING 2-5/16X1-3/4" BOLTS, 4-5/16" WASHERS, AND 2-5/16" NYLON LOCK NUTS,
INSTALL THE DRIVE TUBE TO THE REAR DROP DOWN MECHANISM. ROTATE AND
POSITION TUBE UNTIL ALL 4 MOUNTING HOLES LINE UP AND TORQUE NUTS TO 17 FT-LBS.
INSTALL THE REAR COUPLING TO THE DRIVE TUBE USING THE COUPLING BUSHING AND CLEVIS PIN.
THE COUPLING SHOULD BE INSTALLED SO THAT IT MAY ROTATE WITH THE RED CAP ON TOP
KNAACK L.L.C.
CONFIDENTIAL, PRINTED
COPIES ARE NOT TO BE
REMOVED FROM SITE
WITHOUT WRITTEN CONSENT.
THIRD ANGLE PROTECION
FORMAT
SW
PAGE NUMBER
SCALE:
DATE:
DRAWN BY:
PART NAME:
MATERIAL:
TOLERANCES=
(EXCEPT AS NOTED)
ANGULAR
±1°
LINEAR
±.031
=CONTROL DIMENSION
1:24
2291-3-01 INSTALL 3
PAGE OF
1914
PART NUMBER: REV.
REV.
PART NUMBER:
STEP 10 - INSTALL REAR COUPLING
Install the rear coupling to the drive tube
using the coupling bushing and clevis pin.
The coupling should be installed with the
red cap on top and the open end pointing
AWAY from the center of the van.
5/16 WASHER
5/16 X 1-3/4” BOLT
5/16 LOCK NUT
REAR DRIVE TUBE
COUPLING
BUSHING
CLEVIS PIN
REAR DRIVE TUBE
REAR COUPLING