Use and Care Manual

©2015 KNAACK LLC
2
• Electric Drill
• Drill Bits - 3/8" & 1/2"
• Screwdriver (common)
• 1/2" Open or Box End Wrench
• 9/16" Open or Box End Wrench
• Ratchet Wrench
• 1/2" Socket
TOOLS REQUIRED
PARTS LIST
(4) 5/16-18 x 1"
Hex Head Bolt
(6) 5/16-18 x 1-1/2"
Hex Head Bolt
(1) 5/16-18 x 2-1/4"
Black Oxide Bolt
(6) 5/16"
Lock Washer
(10) 5/16"
Flat Washer
(6) 5/16-18
Blind Fastener
(1)
Installation Tool
(1) Handle
ALUMINUM BED UPFIT KIT PARTS LIST - 32-0244
(2) 5/16-18 x 3/4"
Truss Head Screw
(4) 5/16-18
Nylon Lock Nut
(2) 5/16-18
Whiz Lock Nut
(4)
Vinyl Tape
(1)
Zinc Rich Primer
(28) 1/2" x 1"
Plastic Washer
(4) 11/32" x 7/8"
Plastic Washer
(4) Mounting Plates (1) Rear Mounting Bracket
BLIND FASTENER INSTALLATION
Place a drop of oil on black oxide bolt for lubrication before assembling.
Place the Blind Fastener in the hole and use 1/2" or 7/16" wrench to
tighten black oxide bolt until fastener is fully seated (it will start out hard
and get easier as fastener “bulbs” out).
Make sure the Blind Fastener and Installation Tool do not turn during
installation.
Black Oxide Bolt
Flat Washer
9/16" Wrench
Installation Tool
Blind Fastener
ALUMINUM TRUCK BED INSTALLATION
Coat drilled holes with Zinc Rich Primer. Insert Blind Fastener through one
1/2" x 1" plastic washer. Insert Blind Fastener into drilled hole. Place
second 1/2" x 1" plastic washer through the bottom of the Blind Fastener.
Continue following installation instructions above to install Blind Fasteners.