Use and Care Manual

©2015 KNAACK LLC
3
STEP 1
STEP 2
STEP 2A
Drawer Removal
Open the drawer until it reaches the internal stop brackets. Remove the stop brackets from each upper inside location. Put the
brackets and bolts into the drawer for later installation. Install the drawer handle. Carefully pull the drawer completely out of the
housing, setting it aside. Lift out the front rollers.
Drawer Installation (preferred)
Place the housing in position. Slide a mounting plate
into each open end of the front and rear skids, but no
farther than the leading edge of the slotted hole in the
mounting plate. Mark through the hole for drilling. See
Blind Fastener Installation Instructions and cautions
before drilling. With Blind Fasteners installed, secure by
placing the mounting plate as you had for marking.
Note: Follow gure to the right as a guide.
Drawer Installation (alternate)
Place the housing into the position, and mark through
the outer slotted holes of each skid. Remove the housing
and read the Blind Fastener Installation Instructions and
cautions before drilling each of the hole locations. With all
Blind Fasteners installed, secure the housing. Reinstall the
drawer to the unit by reversing the removal steps shown.
5/16-18 x 1-1/2"
Hex Head Bolt
5/16-18 x 1-1/2"
Hex Head Bolt
5/16"
Lock Washer
5/16"
Lock Washer
5/16"
Flat Washer
5/16"
Flat Washer
MOUNTING
PLATE
1/2" Hole
1/2" Hole
5/16-18
Blind Fastener
5/16-18
Blind Fastener
STOP BRACKETS
DRAWER
HANDLE
5/16-18 x 3/4"
Truss Head Screw
5/16-18
Whiz Lock Nut
FRONT ROLLERS
HOUSING
5/16-18 x 3/4"
Hex Head Bolt
INSTALLATION INSTRUCTIONS
Note: If your truck bed is constructed of aluminum, use zinc rich primer to coat drilled holes.
Follow additional instructions if mounting to an aluminum truck
bed as explained in the Blind Fastener Installation on page 2.
ALUMINUM TRUCK BED INSTALLATION: