Installation Guide

ATTENTION: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS AND WARNINGS
BEFORE ASSEMBLING, INSTALLING OR USING THIS PRODUCT.
WEATHERGUARD.COM
©2015 KNAACK LLC
WEATHERGUARD.COM
INSTALLATION MANUAL
TRUCK STORAGE SOLUTIONS
SECURING YOUR REPUTATION
®
STEEL & ALUMINUM SIDE BOX WITH
PACK RAT
®
DRAWER UNITS
NOTICE
MODELS
DANGER
Use specic aluminum upt components when installing WEATHER GUARD®
products to aluminum truck beds. Follow additional instructions if mounting
to an aluminum truck bed. There may be left over components depending on
upt.
Any modication or unintended use of this product shall immediately void all
manufacturers warranties. Manufacturer disclaims all liability for injuries to
persons or property resulting from any modication to, or unintended use of
this product.
When warning decals cannot be read or when they do not stay afxed to the
transfer tank, the owner of this product is legally responsible for replacing
these warning decals for free by contacting: KNAACK LLC at 420 E. Terra Cotta
Ave., Crystal Lake, IL 60014 or call 1-800-456-7865 fore free replacements.
Danger of explosion. Do not use this product for storing or transporting am-
mables, explosives, hazardous materials, or hazardous waste, such as contain-
ers of gasoline, solvents, gun powder, dynamite, propane tanks, acetylene
tanks and cutting torches. This product is only intended and safe for use in
storing and transporting small tools, equipment and other similar materials.
Any modications made to, or unintended use of this product, could create a
hazardous condition that can cause death, serious personal injury or property
damage.
Part No. 24-3500 REV. O ECN 5583 05/15
WARNING
Prior to drilling, so as not to cut or puncture fuel tanks, fuel lines, electric
wires, etc., check under vehicle for locations. All oor mounting bolts near the
gas tank area should be installed from the underside of the vehicle, to guard
against the gas tank being punctured in the event of a collision. This would
mean not using Blind Fastener in this area. Holes drilled in this area should be
3/8".
CAUTION
Transfer tank bottom must be fully supported by the oor of the truck bed so
as not to cause exing of the tank which could cause stress cracks and leak-
age of the tank. To keep debris out of your eyes when checking the underside
of the vehicle, or when drilling, always wear protective eyewear.
TRANSFER TANKS
Note: X represents the color code for your model: 3 = White | 5 = Black
350-X-01, 351-X-01, 352-X-01, 354-X-01, 357-X-01, 358-X-01, 359-X-01, 360-X-01

Summary of content (4 pages)