Manual

ManualsBrandsWEATHER GUARD ManualsFor the carModel 226-3-01 Mounting Bracket, Ford Transit Connect

PAGE 1

INSTALLATION MANUAL

To keep debris out of your eyes when checking the underside of the vehicle, or when drilling, always wear protective eyewear.

Prior to drilling, so as not to cut or puncture fuel tanks, fuel lines, brake lines, electric wires, etc., check behind or underneath drilling and

mounting locations.

VAN STORAGE SOLUTIONS

CAUTION

PARTS LIST

Qty Description

2 Angle, Front

2 Angle, Rear

1 Bolt Kit

1 Weatherstrip, 1/4 x 2

13mm Wrench 9/16” Open End Wrench

5mm Allen Wrench Center Punch

1/8”, 3/8” Drill Bits Hammer

1/2” Wrench or Socket Pencil

TOOLS NEEDED

Front Angle Rear Angle

ATTENTION: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS AND WARNINGS BEFORE ASSEMBLING, INSTALLING OR USING THIS PRODUCT.

WARNING

WWW.WEATHERGUARD.COM

226-3-01 ROOF RACK for FORD TRANSIT CONNECT

Part No. 24-0283 REV. B ECN 5305 04/13

Summary of content (9 pages)

PAGE 1
INSTALLATION MANUAL 226-3-01 ROOF RACK for FORD TRANSIT CONNECT VAN STORAGE SOLUTIONS WWW.WEATHERGUARD.COM ATTENTION: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS AND WARNINGS BEFORE ASSEMBLING, INSTALLING OR USING THIS PRODUCT. WARNING Prior to drilling, so as not to cut or puncture fuel tanks, fuel lines, brake lines, electric wires, etc., check behind or underneath drilling and mounting locations.
PAGE 2
INSTALLATION INSTRUCTIONS 1 Remove metric bolts from roof on Ford Transit Connect. Metric Bolt Lock Washer BoltKit(8).eps 2 PASSENGER SIDE FRONT ANGLE INSTALLATION SHOWN BELOW. Cut and place weather strip pads on Bottom side of Roof Angles. Flat Washer FRONT OF VAN Apply Sealant Vehicle Roof CENTER OF VAN Weather strip pad 3 For Rear angles use metric hex cap screw M81.25 x 25mm and temporarily install angles on roof. The upright part of the angle will be toward the outside of the van.
PAGE 3
ATTENTION Any modification or unntended use of this product shall immediately void all manufacturers warranties. Manufacturer disclaims all liability for injuries to persons or property resulting from any modification to, or unintended use of this product.
PAGE 4
MANUEL D’INSTALLATION PORTE-ÉCHELLE DE TOIT pour FORD TRANSIT CONNECT VAN STORAGE SOLUTIONS WWW.WEATHERGUARD.COM ATTENTION- PRIÈRE DE LIRE ET DE S’ASSURER DE COMPRENDRE L’ENSEMBLE DES DIRECTIVES ATTENTION: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS AND WARNINGS BEFORE ASSEMBLING, INSTALLING OR USING THIS PRODUCT. ET DES AVERTISSEMENTS AVANT D’ASSEMBLER, D’INSTALLER OU D’UTILISER CE PRODUIT.
PAGE 5
INSTRUCTIONS D’INSTALLATION INSTALLATION DE LA CORNIÈRE AVANT CÔTÉ PASSAGER ILLUSTRÉE CI-APRÈS. 2 Couper et placer les coussinets de caoutchouc d’étanchéité sur le côté inférieur des cornières de toit. AVANT DE FOURGONNETTE Boulon métrique Rondelle de sûreté BoltKit(8).eps 1 Retirer les boulons métriques du toit de la Ford Transit Connect.
PAGE 6
ATTENTION Toute modification ou mauvaise utilisation de ce produit annule aussitôt l’ensemble des garanties du fabricant. Le fabricant décline toute responsabilité pour des blessures personnelles ou dommages matériels découlant de toute modification ou mauvaise utilisation de ce produit.
PAGE 7
MANUAL DE INSTALACIÓN 226-3-01 REJILLA PARA TECHO para FORD TRANSIT CONNECT VAN STORAGE SOLUTIONS WWW.WEATHERGUARD.COM ATTENTION: READ ANDTODAS UNDERSTAND ALL INSTRUCTIONS AND WARNINGSANTES BEFORE INSTALLING OR USING THIS PRODUCT. ATENCIÓN:PLEASE LEA Y ENTIENDA LAS INSTRUCCIONES Y ADVERTENCIAS DEASSEMBLING, ARMAR, INSTALAR O UTILIZAR ESTE PRODUCTO.
PAGE 8
INSTRUCCIONES DE INSTALACIÓN 1 Corte y coloque almohadillas de burlete en el lado inferior de los ángulos para techo. Perno métrico Arandela de presión BoltKit(8).eps 2 ABAJO SE MUESTRA LA INSTALACIÓN DEL ÁNGULO DELANTERO DEL LADO DEL PASAJERO. Retire los pernos métricos del techo de la Ford Transit Connect. Arandela plana FRENTE DE LA VAN Aplique sellador Techo del vehículo Almohadilla de burlete Para ángulos traseros utilice el tornillo hexagonal métrico M8- 1.
PAGE 9
ATENCIÓN Toda modificación o uso indebido de este producto anulará inmediatamente todas las garantías del fabricante. El fabricante se exime de toda responsabilidad por lesiones a personas o daños a la propiedad que resulten de la modificación o el uso indebido de este producto.